HINT
This can be set from −40 to 0 dB.
6.
Make small adjustments to the input volume of the other device.
While checking the audio level meter of the connected device, make adjustments to the input gain of that
device until the audio signal level is about −12 dB.
7.
Tap Test Tone.
This stops test tone output.
NOTE
• See the manual of the connected device for information about its operation.
• The test tone is output from both the LINE OUT and PHONE OUT jacks.
• Be careful with the volume if you are monitoring the sound with headphones, for example.
HINT
The test tone is a 1kHz sine wave at −12 dBFS.
42
To Next Page
Loading...
