Chapter 14 Static Route
EMG2926-Q10A User’s Guide
112
The following table describes the labels in this screen.
Table 44 Network > Static Route: Add/Edit
LABEL DESCRIPTION
Static Route Select to enable or disable this rule.
Route Name Type a name to identify this rule. You can use up to 31 printable English keyboard
characters, including spaces.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Gateway IP
Address
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the
same segment as your EMG2926-Q10A's interface(s). The gateway helps forward packets
to their destinations.
Back Click Back to return to the previous screen without saving.
Apply Click Apply to save your changes back to the EMG2926-Q10A.
Cancel Click Cancel to set every field in this screen to its last-saved value.
To Next Page
Loading...
