Chapter 5 Access Point Mode
EMG2926-Q10A User’s Guide
31
5.3.1 Setting your EMG2926-Q10A to AP Mode
1 Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on
how to do this.
2 To use your EMG2926-Q10A as an access point, go to Maintenance > Sys OP Mode and select
Access Point Mode.
Figure 13 Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As soon
as you do, your EMG2926-Q10A is already in Access Point mode.
3 When you select Access Point Mode, the following pop-up message window appears.
Figure 14 Pop up for Access Point mode
Click OK. Then click Apply. The Web Configurator refreshes once the change to Access Point mode
is successful.
5.3.2 Accessing the Web Configurator in Access Point Mode
Log in to the Web Configurator in Access Point mode, do the following:
1 Connect your computer to the LAN port of the EMG2926-Q10A.
2 The default IP address of the EMG2926-Q10A is “192.168.1.2”. In this case, your computer must
have an IP address in the range between “192.168.1.3” and “192.168.1.254”.
3 Click Start > Run on your computer in Windows. Type “cmd” in the dialog box. Enter “ipconfig” to
show your computer’s IP address. If your computer’s IP address is not in the correct range then see
Appendix B on page 191 for information on changing your computer’s IP address.
4 After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and
type “192.168.1.2” as the web address in your web browser.
To Next Page
Loading...
