EMG2926-Q10A User’s Guide
30
CHAPTER 5
Access Point Mode
5.1 Overview
Use your EMG2926-Q10A as an access point (AP) if you already have a router or gateway on your
network. In this mode your EMG2926-Q10A bridges a wired network (LAN) and wireless LAN
(WLAN) in the same subnet. See the figure below for an example.
Figure 12 Wireless Internet Access in Access Point Mode
Many screens that are available in Router Mode are not available in Access Point Mode, such as
bandwidth management and firewall.
5.2 What You Can Do
•Use the Status screen to view read-only information about your EMG2926-Q10A (Section 5.4 on
page 32).
•Use the LAN screen to set the IP address for your EMG2926-Q10A acting as an access point
(Section 5.5 on page 34).
5.3 What You Need to Know
See Chapter 6 on page 37 for a tutorial on setting up a network with the EMG2926-Q10A as an
access point.
To Next Page
Loading...
