Chapter 20 Remote Management
EMG2926-Q10A User’s Guide
143
Use this screen to remotely turn on a device on the network. Click the Management > Remote
MGMT > Wake On LAN to open the following screen.
Figure 86 Management > Remote MGMT > Wake On LAN
The following table describes the labels in this screen.
20.8 TR069 Screen
TR-069 defines how Customer Premise Equipment (CPE), for example your ZyXEL Device, can be
managed over the WAN by an Auto Configuration Server (ACS). TR-069 is based on sending
Remote Procedure Calls (RPCs) between an ACS and a client device. RPCs are sent in Extensible
Markup Language (XML) format over HTTP or HTTPS.
Table 56 Management > Remote MGMT > Wake On LAN
LABEL DESCRIPTION
Wake On LAN over WAN
Settings
Enable WOL over WAN Select this option to have the EMG2926-Q10A forward a WoL “Magic Packet” to
all devices on the LAN if the packet comes from the WAN or remote network
and uses the port number specified in the Port field. A LAN device whose
hardware supports Wake on LAN then will be powered on if it is turned off
previously.
Port Type a port number from which a WoL packet is forwarded to the LAN.
Wake On LAN
Wake MAC Address Enter the MAC Address of the device on the network that will be turned on.
A MAC address consists of six hexadecimal character pairs.
Start Click this to have the EMG2926-Q10A generate a WoL packet and forward it to
turn the specified device on.
A screen pops up displaying MAC address error if you input the MAC address
incorrectly.
Apply Click Apply to save the setting to the EMG2926-Q10A.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
