Chapter 24 Maintenance
EMG2926-Q10A User’s Guide
173
24.11 Language Screen
Use this screen to change the language for the Web Configurator.
Select the language you prefer and click Apply. The Web Configurator language changes after a
while without restarting the EMG2926-Q10A.
Figure 115 Maintenance > Language
24.12 Diagnostic Ping Screen
Use this screen to ping an IP address.
Access Point Select Access Point Mode if your device bridges traffic between clients on the same
network.
•In Access Point Mode, all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port labeled WAN.
There is no WAN port.
• The DHCP server on your device is disabled.
• The IP address of the device on the local network is set to 192.168.1.2.
Apply Click Apply to save your settings.
Cancel Click Cancel to exit this screen without saving.
Table 69 Maintenance > Sys OP Mode (continued)
LABEL DESCRIPTION
To Next Page
Loading...
