Chapter 5 Access Point Mode
EMG2926-Q10A User’s Guide
34
5.4.1 Navigation Panel
Use the menu in the navigation panel to configure EMG2926-Q10A features in Access Point Mode.
Figure 16 Menu: Access Point Mode
Refer to Table 8 on page 27 for descriptions of the labels shown in the navigation panel.
5.5 LAN Screen
Use this section to configure your LAN settings while in Access Point Mode.
Click Network > LAN to see the screen below.
Note: If you change the IP address of the EMG2926-Q10A in the screen below, you will
need to log into the EMG2926-Q10A again using the new IP address.
Interface This displays the EMG2926-Q10A port types. The port types are: LAN and WLAN.
Status For the LAN ports, this field displays Down (line is down) or Up (line is up or connected).
For the 2.4GHz/5GHz WLAN, it displays Up when the 2.4GHz/5GHz WLAN is enabled or
Down when the 2.4G/5G WLAN is disabled.
Rate For the LAN ports, this displays the port speed and duplex setting or N/A when the line is
disconnected.
For the 2.4GHz/5GHz WLAN, it displays the maximum transmission rate when the 2.4GHz/
5GHz WLAN is enabled and N/A when the WLAN is disabled.
Table 9 Status Screen: Access Point Mode (continued)
LABEL DESCRIPTION
To Next Page
Loading...
