Chapter 20 Remote Management
EMG2926-Q10A User’s Guide
139
The following table describes the labels in this screen.
20.5 Telnet Screen
To change your EMG2926-Q10A’s remote management settings, click Management > Remote
MGMT > Telnet to open the Telnet screen.
Figure 83 Management > Remote MGMT > Telnet
Table 53 Configuration > Management > Remote MGMT > WWW
LABEL DESCRIPTION
HTTPS
Port You may change the server port number for a HTTPS service if needed. However you
must use the same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the EMG2926-Q10A using
this HTTPS service.
Secured Client IP
Address
Select All to allow all computers to access the EMG2926-Q10A using the HTTPS service.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG2926-Q10A.
HTTP
Port You may change the server port number for a HTTP service if needed. However you
must use the same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the EMG2926-Q10A using
this HTTP service.
Secured Client IP
Address
Select All to allow all computers to access the EMG2926-Q10A using this HTTP service.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG2926-Q10A.
Apply Click Apply to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
