Chapter 10 LAN
EMG2926-Q10A User’s Guide
92
10.6 IPv6 LAN Screen
Use this screen to configure the IPv6 address for your EMG2926-Q10A on the LAN. Click Network
> LAN > IPv6 LAN.
Figure 51 Network > LAN > IPv6 LAN
The following table describes the labels on this screen.
IP Subnet Mask The subnet mask specifies the network number portion of an IP address. Your
EMG2926-Q10A will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the EMG2926-Q10A.
Apply Click Apply to save your changes back to the EMG2926-Q10A.
Cancel Click Cancel to begin configuring this screen afresh.
Table 32 Network > LAN > IP Alias (continued)
LABEL DESCRIPTION
Table 33 Network > LAN > IPv6 LAN
LABEL DESCRIPTION
Enable DHCPv6-PD Select this option to use DHCPv6 prefix delegation. The EMG2926-Q10A will obtain an
IPv6 prefix from the ISP or a connected uplink router for the LAN.
Static IP Address Select this option to manually enter an IPv6 address if you want to use a static IP
address.
LAN IPv6 Address Enter the IPv6 address for the EMG2926-Q10A on the LAN.
Apply Click Apply to save your changes with the EMG2926-Q10A.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
