Chapter 24 Maintenance
EMG2926-Q10A User’s Guide
170
Restore configuration allows you to upload a new or previously saved configuration file from your
computer to your EMG2926-Q10A.
Click Maintenance > Backup/Restore. Information related to factory defaults, backup
configuration, and restoring configuration appears as shown next.
Figure 110 Maintenance > Backup/Restore
The following table describes the labels in this screen.
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default
EMG2926-Q10A IP address (192.168.1.1). See Appendix B on page 191 for details
on how to set up your computer’s IP address.
Table 68 Maintenance > Backup/Restore
LABEL DESCRIPTION
Backup Configuration
Backup Click Backup to save the EMG2926-Q10A’s current configuration to your computer.
Restore Configuration
File Path Click Choose File to browse to the location of the configuration file in your computer.
Upload Click Upload to begin the upload process.
Note: Do not turn off the EMG2926-Q10A while configuration file upload is in progress.
After you see a “configuration upload successful” screen, you must then wait one minute
before logging into the EMG2926-Q10A again. The EMG2926-Q10A automatically restarts in
this time causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Reset Pressing the Reset button in this section clears all user-entered configuration information
and returns the EMG2926-Q10A to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
EMG2926-Q10A. Refer to the chapter about introducing the Web Configurator for more
information on the RESET button.
To Next Page
Loading...
