Chapter 5 Access Point Mode
EMG2926-Q10A User’s Guide
36
First DNS Server
Second DNS Server
Third DNS Server
Select Obtained From ISP if your ISP dynamically assigns DNS server information
(and the EMG2926-Q10A's WAN IP address). The field to the right displays the
(read-only) DNS server IP address that the ISP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the DNS
server's IP address in the field to the right. If you chose User-Defined, but leave
the IP address set to 0.0.0.0, User-Defined changes to None after you click
Apply. If you set a second choice to User-Defined, and enter the same IP
address, the second User-Defined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. If you do not configure a
DNS server, you must know the IP address of a computer in order to access it.
Apply Click Apply to save your changes to the EMG2926-Q10A.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 10 Network > LAN > IP (continued)
LABEL DESCRIPTION
To Next Page
Loading...
