ZyXEL Communications IES-1000 - Password Commands; SNMP Commands; Sys Commands

IES-1000 User’s Guide
22-16 Commands Introduction
Table 22-1 Commands
MODULE COMMAND DESCRIPTION
delete <netName>
Deletes a subnet.
flush
Removes all subnets.
version
Shows the version information for the
IP module.
isfs
trace
Shows the ISFS trace level.
<level>
Sets the ISFS trace level.
version
Shows version information for the
ISFS module.
passwd
Changes the management password.
restart
Saves the configuration and restarts
the system.
snmp
access <read | write> <community>
[<ip>]
Adds an SNMP access entry.
delete <community> [<ip>]
Deletes an SNMP access entry.
flush
Deletes all SNMP access entries.
list
Lists all SNMP access entries.
trap add <community> <ip>
Adds a trap destination.
delete <community> <ip>
Deletes a trap destination.
flush
Deletes all trap destinations.
list
Lists all trap destinations.
config save
Saves access entries and trap
destinations to the nonvolatile
memory.
sys
info
Shows the system information.
set name [<name>]
Sets or clears the system name.
contact [<name>]
Sets the contact person’s name.
chassis <id>
Sets the chassis ID number.
location [<loc>]
Sets or clears the location.
mode <fast | normal>
Sets the bridge operation mode.
slot <id>
Sets the slot ID.
errlog clear
Clears the system error log.
display
Shows the system error log.
syslog
Shows the syslog setting.
enable | disable
Enables or disables the syslog.