ZyXEL Communications IES-1000 - Figure 10-2 Bridge Setup; Table 10-2 Bridge Setup

IES-1000 User’s Guide
Getting Started Screens 10-3
Figure 10-2 Bridge Setup
The following table describes this screen.
Table 10-2 Bridge Setup
LABEL DESCRIPTION
Operating Mode
Bridge Mode Choose Normal or Fast from the drop-down list box. The Normal mode supports
802.1Q tagged VLAN (enabled in VLAN Setup), which allows tagged/untagged frames to
and from all ports. The Fast mode allows tagged frames on the LAN port and untagged
frames on the ADSL ports.
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to the left to save your changes to the non-volatile memory when you
are done configuring.
Normal Mode
Setting
Packet Type Filter Click this link to go to a screen for editing the packet filter type for each port.
Port Filter Click this link to go to a screen for editing each port's egress (outgoing) ports.
MAC Filter Click this link to go to a screen for editing the MAC filtering for each port.