IES-1000 User’s Guide
33-4 IP Commands
This command removes all of the subnets.
33.2.8 Route Add Command
Syntax:
192.168.1.1 ip> route add <dom name> a.b.c.d <relay> [am:bm:cm:dm [<cost>
[<timeout>]]]
where
<dom name> =
The name of the static route.
a.b.c.d =
The destination IP address of packets that this static route is to route.
<relay> =
The IP address of the gateway that you want to send the packets through.
am:bm:cm:dm =
The destination subnet mask of packets that this static route is to route.
<cost> =
The metric (hop count) of this static route.
<timeout> =
The timeout period of this static route in seconds.
This command defines a new, static IP forwarding route or edits an existing one. Type “route” without any
parameters to view a list of the configured static routes.
Use 0’s for the destination IP address and subnet mask to configure a default static route for the device. The
device uses the default static route to forward packets for which it cannot find another route. The following is
the syntax for configuring a static route.
192.168.1.1 ip> route add <dom name> 0.0.0.0 <relay> 00:00:00:00
33.2.9 Route Delete Command
Syntax:
192.168.1.1 ip> route delete <dom name>
where
<dom name> =
The name of the static route.
This command removes a static, IP forwarding route.
33.2.10 Route Flush Command
Syntax:
192.168.1.1 ip> route flush
This command removes all of the static IP forwarding routes.
33.2.11 Enable Command
Your telnet session disconnects when you change the Ethernet port’s IP address. Initiate a
telnet session to the new IP address in order to reconnect.
To Next Page
Loading...
Need help?
General
