IES-1000 User’s Guide
VLAN 15-5
Table 15-2 Static VLAN Setup
LABEL DESCRIPTION
Management
VLAN ID
The management VLAN ID is the number of the VLAN through which you manage the IES-
1000. The management VLAN defines which ports you can use to manage the IES-1000.
You cannot manage the IES-1000 via a port that is not a member of the management VLAN.
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to the left to save your changes to the non-volatile memory when you are
done configuring.
VLAN ID This field displays the ID number of the VLAN. Click an entry’s VLAN ID to go to a screen
where you can edit that VLAN.
Name This field displays the name of this VLAN.
Active This field displays Yes when the entry is activated and No when the entry is empty.
Add Click this button to configure a new VLAN.
Delete Select a VLAN(s)’s Delete check box and click the Delete button to remove the VLAN.
15.8.1 Add or Edit VLAN Static Entry Screen
Click VLAN Setup in the navigation panel and then Add or a VLAN ID in the VLAN Setup screen.
Use this menu to set up IEEE 802.1Q VLAN parameters for the IES-1000.
Figure 15-2 Add VLAN Static Entry
To Next Page
Loading...
