ZyXEL Communications IES-1000 - Passwd Command; Config Print Command; Exit Command; Sys Commands

IES-1000 User’s Guide
23-2 System Commands
This command changes the management password. The management password is used for authentication at
console or Telnet login. This command is only allowed for local console management sessions. The management
password must be from 1 to 8 characters long and any character is accepted. The factory default password is
“1234”.
It is very important that you remember your password. If you forget it, refer to the
Troubleshooting section for help.
23.2.5 Config Print Command
Syntax:
192.168.1.1> config print
This command lists all current system configuration settings.
23.2.6 Exit Command
Syntax:
192.168.1.1> exit
This command terminates the console or telnet management session.
23.3 Sys Commands
23.3.1 Info Command
Syntax:
192.168.1.1 sys> info
This command displays system related information.
23.3.2 Set Name Command
Syntax:
192.168.1.1 sys> set name <name>
This command allows you to set the name of your IES-1000. The previous setting will be cleared if the command
is entered with the <name> parameter omitted.
23.3.3 Set Contact Command
Syntax: