EasyManua.ls Logo

ZyXEL Communications IES-22A - Page 252

ZyXEL Communications IES-22A
448 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 42 Commands
IES-708-22A User’s Guide
252
ppvc set <portlist> <vpi> <vci>
<encap> <pvid>
<priority>
(STUC mode only) Set priority
PVC.
H/H
ppvc member show [portlist] [<vpi> <vci>] (STUC mode only) Display PPVC
member settings.
M/L
ppvc member set <portlist> <vpi> <vci>
<member vpi> <member
vci> <DS vcprofile[,US
vcprofile]> <level>
(STUC mode only) Set PPVC
member.
H/H
ppvc member delete <portlist> <vpi> <vci>
<member vpi> <member
vci>
(STUC mode only) Remove
PPVC member.
H/H
ppvc delete <portlist> <vpi> <vci> (STUC mode only) Remove
Priority PVC.
H/H
rpvc gateway set <gateway ip> <vlan id>
[<priority>]
(STUC mode only) Set gateway
for RPVC
H/H
rpvc gateway delete <gateway ip> (STUC mode only) Delete
gateway for RPVC
H/H
rpvc gateway show (STUC mode only) Display
gateway for RPVC
M/L
rpvc set <portlist> <vpi> <vci>
<DS vcprofile[,US
vcprofile]> <ip>/
<netmask> <gateway ip>
(STUC mode only) Set RPVC on
a port
H/H
rpvc delete <portlist> <vpi> <vci> (STUC mode only) Delete RPVC
on a port
H/H
rpvc show <portlist> (STUC mode only) Display RPVC
on a port
M/L
rpvc route set <port number> <vpi>
<vci> <ip>/<netmask>
(STUC mode only) Set RPVC
routing subnet on a port
H/H
rpvc route delete <port number> <vpi>
<vci> <ip>/<netmask>
(STUC mode only) Delete RPVC
routing subnet on a port
H/H
rpvc route show <portlist> (STUC mode only) Display RPVC
routing subnet on a port
M/L
rpvc arp agingtime show (STUC mode only) Display RPVC
ARP proxy aging time
M/L
rpvc arp agingtime set <sec,
10..10000|0:disabled>
(STUC mode only) Set RPVC
ARP proxy aging time
H/H
rpvc arp flush (STUC mode only) Flush RPVC
ARP proxy table
H/H
rpvc arp show (STUC mode only) Show RPVC
ARP proxy table
M/L
queuemap show Displays the xDSL priority level to
physical queue mapping.
M/L
queuemap set <priority> <queue level> Set the xDSL priority level to
physical queue mapping.
H/H
alarmprofile show [profile] Displays alarm profiles and their
settings.
L/L
Table 89 Commands (continued)
CLASS COMMAND PARAMETERS DESCRIPTION P

Table of Contents

Related product manuals