Chapter 13 Switch Features
IES4005M User’s Guide
111
dest-l4-port range <start-
port> <end-port>
Specifies a layer 4 destination port range. C 13
source-l4-port <port>
Specifies a layer 4 source port.
port: 0-65535
C13
dest-l4-port <port>
Specifies an layer 4 destination port. C 13
no change-qos
Disables changing the QoS level of matched packets. C 13
no ether-type
Removes the Ethernet type from the profile. C 13
no source-mac
Removes the source MAC from the profile. C 13
no dest-mac
Removes the destination MAC from the profile. C 13
no source-oui
Removes the source MAC OUI from the profile. C 13
no dest-oui
Removes the destination MAC OUI from the profile. C 13
no inner-vlan
Removes the inner VLAN ID from the profile. C 13
no outer-vlan
Removes the outer VLAN ID from the profile. C 13
no inner-pbit
Removes the inner VLAN priority bit from the profile. C 13
no outer-pbit
Removes the outer VLAN priority bit from the profile. C 13
no source-ip
Removes the source IP address or IP address range from the
profile.
C13
no dest-ip
Removes the destination IP address or IP address range from the
profile.
C13
no protocol
Removes the IP protocol from the profile. C 13
no ip-precedence
Removes the IP precedence from the profile. C 13
no dscp
Removes the IP DSCP from the profile. C 13
no source-ipv6
Removes the source IPv6 address from the profile. C 13
no dest-ipv6
Removes the destination IPv6 address from the profile. C 13
no next-header
Removes the IPv6 next header from the profile. C 13
no traffic-class
Removes the IPv6 traffic class from the profile. C 13
no source-l4-port
Removes the source L4 port or L4 port range from the profile. C 13
no dest-l4-port
Removes the destination L4 port or L4 port range from the profile. C 13
Use the following sub-commands to set the actions for the ACL profile.
change-qos <queue-id>
Change the QoS level of matched packets.
queue-id: 0-7
7:highest priority
0:lowest priority
C13
drop
Discards packets that match the profile. C 13
no drop
Disables dropping of matching packets. C 13
rate-limit <rate-limit>
Limits the receiving rate for packets that match the profile.
rate-limit: 32-100000 in kbps
C13
no rate-limit
Disables rate limiting for matching packets. C 13
change-inner-pbit <pbit>
Changes the inner VLAN inner priority bit of matching packets to
the specified one.
C13
Table 75 ACL Commands Summary (continued)
COMMAND DESCRIPTION M P
To Next Page
Loading...
