ZyXEL Communications IES4005M - Page 158

Chapter 22 QoS
IES4005M User’s Guide
158
This table describes the commands.
queue-id
The QoS queue. 0-7
weight
The weight of a Weighted Roud Robin (WRR) or Weighted Fair Queueing (WQF)
queue. 1-50. Default 50.
Table 109 QoS Command Parameters (continued)
NOTATION DESCRIPTION
Table 110 QoS Commands Summary
COMMAND DESCRIPTION M P
qos atm vc-shaping
Enables per-Virtual Circuit (VC) shaping for Asynchronous Transfer
Mode (ATM) Virtual Circuits (VCs).
C13
no qos atm vc-shaping
Disables per-VC shaping for ATM VC. C 13
interface dsl <slot/portlist>
Enters the sub-command mode for configuring the specified DSL ports. C 13
qos shaping-profile
<profile-name>
Configures a QoS shaping profile on the specified DSL ports. C 13
qos weight-profile
<profile-name>
Configures a Weighted Roud Robin or Weighted Fair Queueing profile on
the specified DSL ports.
C13
qos algorithm sp|wfq|sp-
wfq|shaping
Sets which QoS algorithm to use on the specified DSL ports.
sp: Strict Priority, queue7 has the highest priority
wfq: Weighted Fair Queueing.
sp-wfq: Strict Priority + Weighted Fair Queueing. Queues 5-0 are
scheduled by WFQ first, and the output of WFQ, queue 7, and queue 6
are scheduled by Strict Priority. Queue 7 has the highest priority, and
the output of WFQ has the lowest priority.
shaping: Strict Priority + shaping. Every queue has its own shaping
rate. After shaping, every queue is scheduled by Strict Priority. Queue
7 has the highest priority.
C13
qos max-rate <rate>
Configures the maximum rate. C 13
qos atm-vc <vpi>/<vci>
vc-shaping-profile
<profile-name>
Configures an ATM shaping profile on the specified ATM VCs. C 13
exit
Leaves the DSL port configuration. C 13
qos shaping-profile <name>
Enters the sub-command mode for configuring the specified shaping
profile.
C13
exit
Leaves the shaping profile sub-command mode. C 13
queue7 max-rate <rate>
depth <depth>
Configures the maximum rate and maximum number of packets queue
7 allows.
C13
queue6 max-rate <rate>
depth <depth>
Configures the maximum rate queue 6 allows. C 13
queue5 max-rate <rate>
depth <depth>
Configures the maximum rate queue 5 allows. C 13
queue4 max-rate <rate>
depth <depth>
Configures the maximum rate queue 4 allows. C 13
queue3 max-rate <rate>
depth <depth>
Configures the maximum rate queue 3 allows. C 13
queue2 max-rate <rate>
depth <depth>
Configures the maximum rate queue 2 allows. C 13