ZyXEL Communications IES4005M - Page 176

Chapter 24 VDSL
IES4005M User’s Guide
176
xtur-15min-errcoding-
threshold <threshold>
Configures the number of Code Violations (incorrect cyclic
redundancy check) allowed on the subscriber devices within 15
minutes. 0- 2147483647, default: 0.
C13
xtur-15min-corrected-
threshold <threshold>
Configures the number of corrected error blocks allowed on the
subscriber devices within 15 minutes. 0- 2147483647, default: 0.
C13
no dsl line-template <name>
Removes the specified DSL line template. C 13
show dsl line-template [name]
Displays the names of all the DSL line templates if a name is not
specified or the contents of the specified DSL line template.
E13
dsl line-template <name>
Enters the sub-command mode for configuring the specified DSL
line template.
C13
exit
Leaves the DSL line template configuration sub-command mode. C 13
channel-profile <name>
Configures the referenced DSL channel profile. Default: DEFVAL C 13
line-profile <name>
Configures the referenced DSL line profile. Default: DEFVAL C 13
no dsl alarm-template <name>
Removes the specified DSL alarm template. C 13
show dsl alarm-template <name>
Displays the names of all the DSL alarm templates if a name is not
specified or the contents of the specified DSL alarm template.
E13
dsl alarm-template <name>
Enters the sub-command mode for configuring the specified DSL
alarm template.
C13
exit
Leaves the DSL alarm template configuration sub-command
mode.
C13
alarm-channel-profile <name>
Configures the referenced DSL alarm channel profile. Default:
DEFVAL
C13
alarm-line-profile <name>
Configures the referenced DSL alarm line profile. Default: DEFVAL C 13
interface dsl <slot/portlist>
Enters the sub-command mode for configuring the specified DSL
ports.
C13
exit
Leaves the DSL port configuration. C 13
active
Enables the specified DSL port(s) on the IES. C 13
no active
Disables the specified DSL port(s) on the IES. C 13
name <port-name-string>
Sets a name of up to 31 printable characters for the port(s).
default:
C13
line-template <line-template>
Configures the referenced DSL line template to the specified DSL
ports.
line-template: up to 31 printable characters
C13
alarm-template <alarm-
template>
Configures the referenced DSL alarm template to the specified
DSL ports.
line-template: up to 31 printable characters, default is
DEFVAL
C13
show interface dsl <slot/
portlist> config
Displays the DSL configuration of the specified DSL ports. E 13
show interface dsl <slot/
portlist> lineinfo
Displays the current 15 minutes DSL line information for the
specified DSL ports.
E13
show interface dsl <slot/
portlist> linerate
Displays the current 15 minutes DSL line rate for the specified
DSL ports.
E13
show interface dsl <slot/
portlist> status
Displays the current 15 minutes DSL line status for the specified
DSL ports.
E13
Table 116 VDSL Commands Summary (continued)
COMMAND DESCRIPTION M P