ZyXEL Communications IES4005M - Page 84

Chapter 11 Management
IES4005M User’s Guide
84
This table describes the commands.
Table 58 Alarm Commands Summary
COMMAND DESCRIPTION M P
show alarm current [severity <severity>] [alarm
<alarm>] [condition <condition>] [start-date
<month>/<day>/<year>] [end-date <month>/<day>/
<year>] [forward|reverse] [detail] [indexes]
Displays current alarms.
indexes displays alarm indexes information
E1
clear alarm current [condition <condition>
indexes <index1>/<index2>/<index3>]
Clears all clearable current alarms or alarms
with the specified condition code and indexes
condition: check for alarm definition table
for allowed condition
index1: target alarm index1, check for
indexes of alarm current table
index2: target alarm index2, check for
indexes of alarm current table
index3: target alarm index3, check for
indexes of alarm current table
E13
show alarm history [severity <severity>] [alarm
<alarm>] [condition <condition>] [start-date
<month>/<day>/<year>] [end-date <month>/<day>/
<year>] [forward|reverse] [detail]
Displays alarm history. E 1
clear alarm history [severity <severity>] |
[alarm <alarm>] | [condition <condition>]
Clears historical alarms with the specified
severity or specified alarm or specified
condition or all severities.
E13
alarm definition alarm <alarm> condition
<condition> severity <severity> [syslog-
facility <facility>] [target <target>]
[clearable]
Configures the specified alarm definition.
condition: check the alarm definition table
for allowed conditions or condition codes
clearable: alarm is clearable
C13
show alarm definition [alarm <alarm>] [condition
<condition>] [severity <severity>] [target
<target>]
Displays the alarm definition table. E 1
alarm cutoff
Issues an alarm cutoff to stop signaling an
alarm.
E13
show interface dsl <slot/portlist> alarm line-
control
Displays the time interval settings for
reporting alarms when you enable alarm line-
control on the specified DSL ports.
E1
show interface dsl <slot/portlist> alarm
notification-severity
Displays the minimum severity level to send
out alarm notifications (SNMP trap and
SYSLOG) on the specified DSL ports.
E1
interface dsl <slot/portlist>
Enters the sub-command mode for configuring
the specified DSL ports.
C13
exit
Leaves the DSL port configuration. C 13
alarm line-control
Has the IES report alarms for the ports at
regular intervals instead of immediately.
C13
no alarm line-control
Turns off interval-based reporting of alarms so
the IES reports alarms immediately.
C13
alarm line-control interval <interval>
Sets the time interval (10-600 seconds) the
IES uses for sending alarms about these
ports. This applies when you enable alarm
line-control on these ports.
C13