Chapter 22 Addresses
NXC Series User’s Guide
289
Figure 166 Configuration > Object > Address > Address
The following table describes the labels in this screen.
22.2.1 Add/Edit Address
The Add/Edit Address screen allows you to create a new address or edit an existing one. To access this
screen, go to the Address screen, and click either the Add icon or an Edit icon.
Figure 167 Configuration > Object > Address > Address > Add/Edit
Table 136 Configuration > Object > Address > Address
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to remove it before
doing so.
Object
References
Select an entry and click Object References to open a screen that shows which settings use the
entry.
# This field is a sequential value, and it is not associated with a specific address.
Name This field displays the configured name of each address object.
Type This field displays the type of each address object. “INTERFACE” means the object uses the
settings of one of the NXC’s interfaces.
IPv4/IPv6 Address This field displays the IP addresses represented by each address object. If the object’s settings
are based on one of the NXC’s interfaces, the name of the interface displays first followed by
the object’s current address settings.
Reference This field displays the number of times an object reference is used in a profile.
To Next Page
Loading...
