ZyXEL Communications NXC Series - Editing USB Storage Log Settings

Chapter 30 Log and Report
NXC Series User’s Guide
383
30.3.3 Editing USB Storage Log Settings
The Edit Log on USB Storage Setting screen controls the detailed settings for saving logs to a connected
USB storage device. Go to the Log Settings Summary screen, and click the USB storage Edit icon.
Figure 234 Configuration > Log & Report > Log Settings > Edit (USB Storage)
The following table describes the labels in this screen.
Table 188 Configuration > Log & Report > Log Settings > Edit (USB Storage)
LABEL DESCRIPTION
Duplicate logs to
USB storage (if
ready)
Select this to have the NXC save a copy of its system logs to a connected USB storage device.
Use the Active Log section to specify what kinds of messages to include.
Active Log
Selection Use the Selection drop-down list to change the log settings for all of the log categories.
disable all logs (red X) - do not send the remote server logs for any log category.
enable normal logs (green check mark) - send the remote server log messages and alerts for
all log categories.
enable normal logs and debug logs (yellow check mark) - send the remote server log
messages, alerts, and debugging information for all log categories.
# This field is a sequential value, and it is not associated with a specific entry.