NXC Series User’s Guide
331
CHAPTER 28
DHCPv6
28.1 Overview
This chapter describes how to configure DHCPv6 request type objects.
28.1.1 What You Can Do in this Chapter
The Request screen (Section 28.2 on page 331) allows you to configure DHCPv6 request type objects.
28.2 DHCPv6 Request
The Request screen allows you to add, edit, and remove DHCPv6 request type objects. To access this
screen, click Configuration > Object > DHCPv6 > Request.
Figure 193 Configuration > Object > DHCPv6 > Request
The following table describes the labels in this screen.
Table 161 Configuration > Object > DHCPv6 > Request
LABEL DESCRIPTION
Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to remove it before
doing so.
Note: You cannot delete an entry which is in use.
Object
References
Select an entry and click Object References to open a screen that shows which settings use the
entry.
# This field is a sequential value, and it is not associated with a specific object.
Name This field displays the name of each request object.
Type This field displays the request type of each request object.
To Next Page
Loading...
