Chapter 29 System
NXC Series User’s Guide
373
Figure 228 Configuration > System > Auth. Server > Add/Edit
The following table describes the labels in this screen.
29.13 Language
Click Configuration > System > Language to open this screen. Use this screen to select a display
language for the NXC’s Web Configurator screens.
Figure 229 Configuration > System > Language
Table 182 Configuration > System > Auth. Server > Add/Edit
LABEL DESCRIPTION
Activate Select this check box to make this profile active.
Profile Name Enter a descriptive name (up to 31 alphanumerical characters) for identification purposes.
IP Address Enter the IP address of the RADIUS client that is allowed to exchange messages with the NXC.
Netmask Enter the subnet mask of the RADIUS client.
Secret Enter a password (up to 64 alphanumeric characters) as the key to be shared between the
NXC and the RADIUS client.
The key is not sent over the network. This key must be the same on the external authentication
server and the NXC.
Description Enter the description of each server, if any. You can use up to 60 printable ASCII characters.
OK Click OK to save the changes.
Cancel Click Cancel to discard the changes.
To Next Page
Loading...
