Chapter 31 File Manager
NXC Series User’s Guide
398
After you see the Firmware Upload in Process screen, wait two minutes before logging into the NXC
again.
Figure 240 Firmware Upload In Process
Note: The NXC automatically reboots after a successful firmware update.
The NXC automatically restarts causing a temporary network disconnect. In some operating systems,
you may see the following icon on your desktop.
Figure 241 Network Temporarily Disconnected
After five minutes, log in again and check your new firmware version in the Dashboard screen.
If the firmware update was not successful, the following message appears in the screen.
Figure 242 Firmware Upload Error
31.4 Shell Script
Use shell script files to have the NXC use commands that you specify. Use a text editor to create the shell
script files. They must use a “.zysh” filename extension.
Browse... Click Browse... to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click Upload to begin the upload process. This process may take up to two minutes.
Upload Firmware Status
Version This is the version of the firmware that you uploaded.
Released Date This is the date that the firmware was created.
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.
Table 193 Maintenance > File Manager > Firmware Package (continued)
LABEL DESCRIPTION
To Next Page
Loading...
