ZyXEL Communications NXC Series - Console Speed

Chapter 29 System
NXC Series User’s Guide
339
7 Click Apply.
To get the NXC date and time from a time server:
1 Click System > Date/Time.
2 Select Get from Time Server under Time and Date Setup.
3 Under Time Zone Setup, select your Time Zone from the list.
4 Under Time and Date Setup, enter a Time Server Address.
5 Click Apply.
29.5 Console Speed
This section shows you how to set the console port speed when you connect to the NXC via the console
port using a terminal emulation program. See Table 4 on page 23 for default console port settings.
Click Configuration > System > Console Speed to open this screen.
Figure 199 Configuration > System > Console Speed
The following table describes the labels in this screen.
Table 167 Configuration > System > Console Speed
LABEL DESCRIPTION
General Settings
Console Port Speed Use the drop-down list box to change the speed of the console port. Your NXC supports
9600, 19200, 38400, 57600, and 115200 bps (default) for the console port.
The Console Port Speed applies to a console port connection using terminal emulation
software and NOT the Console in the NXC Web Configurator Status screen.
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.