ZyXEL Communications NXC Series - Add;Edit Trusted Client

Chapter 29 System
NXC Series User’s Guide
372
Figure 227 Configuration > System > Auth. Server
The following table describes the labels in this screen.
29.12.1 Add/Edit Trusted Client
Click Configuration > System > Auth. Server to display the Auth. Server screen. Click the Add icon or an
Edit icon to display the following screen. Use this screen to create a new entry or edit an existing one.
Table 181 Configuration > System > Auth. Server
LABEL DESCRIPTION
General Settings
Enable
Authentication
Server
Select the check box to have the NXC act as a RADIUS server.
Authentication
Server Certificate
Select the certificate whose corresponding private key is to be used to identify the NXC to the
RADIUS client. You must have certificates already configured in the My Certificates screen.
Authentication
Method
Select an authentication method if you have created any in the Configuration > Object > Auth.
Method screen.
Trusted Client This specifies from which computers you can access which NXC zones.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after the
selected entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to remove it before
doing so. Note that subsequent entries move up by one when you take this action.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
# This is the index number of the entry.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
Profile Name This field indicates the name assigned to the profile.
IP Address This is the IP address of the RADIUS client that is allowed to exchange messages with the NXC.
Mask This is the subnet mask of the RADIUS client.
Description This is the description of the RADIUS client.
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.