Chapter 29 System
NXC Series User’s Guide
345
29.6.10 Add Service Control
Click the Add icon in the Service Control table to add a service control rule.
Figure 204 Configuration > System > DNS > Add Service Control Rule
The following table describes the labels in this screen.
29.7 WWW Overview
The following figure shows secure and insecure management of the NXC coming in from the WAN.
HTTPS and SSH access are secure. HTTP, and Telnet management access are not secure.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
Table 171 Configuration > System > DNS > Add MX Record (continued)
LABEL DESCRIPTION
Table 172 Configuration > System > DNS > Add Service Control Rule
LABEL DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in this screen.
Address Object Select ALL to allow or deny any computer to send DNS queries to the NXC.
Select a predefined address object to just allow or deny the computer with the IP address that
you specified to send DNS queries to the NXC.
Zone Select ALL to allow or prevent DNS queries through any zones.
Select a predefined zone on which a DNS query to the NXC is allowed or denied.
Action Select Accept to have the NXC allow the DNS queries from the specified computer.
Select Deny to have the NXC reject the DNS queries from the specified computer.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
