Chapter 30 Log and Report
NXC Series User’s Guide
389
System log Select which events you want to log by Log Category. There are three choices:
disable all logs (red X) - do not log any information from this category.
enable normal logs (green check mark) - create log messages and alerts from this category.
enable normal logs and debug logs (yellow check mark) - create log messages, alerts, and
debugging information from this category; the NXC does not e-mail debugging information,
however, even if this setting is selected.
USB Storage Select which event log categories to save to a connected USB storage device. There are three
choices:
disable all logs (red X) - do not log any information from this category.
enable normal logs (green check mark) - save log messages and alerts from this category.
enable normal logs and debug logs (yellow check mark) - save log messages, alerts, and
debugging information from this category.
E-mail Server 1 E-
mail
Select whether each category of events should be included in the log messages when it is e-
mailed (green check mark) and/or in alerts (red exclamation point) for the e-mail settings
specified in E-Mail Server 1. The NXC does not e-mail debugging information, even if it is
recorded in the System log.
E-mail Server 2 E-
mail
Select whether each category of events should be included in log messages when it is e-
mailed (green check mark) and/or in alerts (red exclamation point) for the e-mail settings
specified in E-Mail Server 2. The NXC does not e-mail debugging information, even if it is
recorded in the System log.
Remote Server
1~4
For each remote server, select what information you want to log from each Log Category
(except All Logs; see below). Choices are:
disable all logs (red X) - do not log any information from this category.
enable normal logs (green check mark) - log regular information and alerts from this category.
enable normal logs and debug logs (yellow check mark) - log regular information, alerts, and
debugging information from this category.
OK Click this to save your changes and return to the previous screen.
Cancel Click this to return to the previous screen without saving your changes.
Table 190 Configuration > Log & Report > Log Settings > Log Category Settings (continued)
LABEL DESCRIPTION
To Next Page
Loading...
