Appendix A Log Descriptions
NXC Series User’s Guide
461
AP Receiving Complete ZySH
Configuration from WLAN
Controller.
WTP receiving total configuration from WLAN Controller during
CAPWAP protocol handshaking. (Configuration Change State)
AP Receiving Updating ZySH
Configuration from WLAN
Controller.
WTP receiving total configuration from WLAN Controller When AC
changed configuration. (RUN State)
STA List Full. STA List of AP [%s]
is Full
Number of stations connecting to the specified AP has reached its
upper limit.
1st %s: WTP's description.
DNS Query result is NULL.
A DNS query failed.
Table 228 AP Load Balancing Logs
LOG MESSAGE DESCRIPTION
kick station
%02x:%02x:%02x:%02x:%0
2x:%02x
Indicates that the specified station was removed from an AP’s wireless network
because the AP became overloaded.
Table 229 Rogue AP Logs
LOG MESSAGE DESCRIPTION
rogue ap detection is
enabled.
Indicates that rogue AP detection is enabled.
Table 230 Wireless Frame Capture Logs
LOG MESSAGE DESCRIPTION
Capture done!
check_size:%d,
max_file_size:%d\n
This message displays check_size %d and max_file_size %d when the wireless frame
capture has been completed.
1st %d: total files size of directory.
2nd %d: max files size.
Can not initial
monitor mode signal
handler.\n
While an AP is in Monitor mode, the handler functions as a daemon; if it fails to
initialize the handler, then this message is returned.
Table 231 DCS Logs
LOG MESSAGE DESCRIPTION
dcs init failed!\n
Indicates that the NXC failed to initialize the dcs daemon.
init zylog fail\n
Indicates that the NXC failed to initialize zylog.
Table 227 CAPWAP Client Logs
LOG MESSAGE DESCRIPTION
To Next Page
Loading...
