Chapter 6 Monitor
NXC Series User’s Guide
98
6.11.2.1 Edit Bluetooth Advertising
Use this screen to modify the AP’s Bluetooth advertising settings.
To access this screen, click the Edit button in the Monitor > Wireless > AP information > AP List > Edit AP List
> Bluetooth Settings screen.
Figure 54 Monitor > Wireless > AP Information > AP List > Edit AP List > Bluetooth Settings > Edit
The following table describes the labels in this screen.
Automatically
Extinguish After
Enter a time interval between 1 and 60 minutes to stop the locator LED from blinking. The
locator LED will start to blink for the number of minutes set here.
If you make changes to the time default setting, it will be stored as the default when the AP
restarts.
Reset AP Configuration
This section is available only when the AP is online.
Apply Factory
Default
Click the button to reset all of the AP settings to the factory defaults.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to close the window with changes unsaved.
Table 39 Monitor > Wireless > AP Information > AP List > Edit AP List (continued)
LABEL DESCRIPTION
Table 40 Monitor > Wireless > AP Information > AP List > Edit AP List > Bluetooth Settings > Edit
LABEL DESCRIPTION
General Settings
Activate Select this option to enable the Bluetooth advertising settings.
UUID To specify a UUID of the AP’s beacon ID, enter 32 hexadecimal digits in the range of “A-
F”, “a-f” and “0-9”, split into five groups separated by hyphens (-). The UUID format is as
follows: xxxxxxxx-xxxx-xxxx-xxxx-xxxxxxxxxxxx (8-4-4-4-12).
Generate new UUID Click this button to have the AP generate a UUID automatically.
Major Enter an integer from 0 to 65535 as the major value to identify the beacon.
Minor Enter an integer from 0 to 65535 as the minor value to identify the beacon.
OK Click OK to save your changes back to the AP.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
