Chapter 7 Wireless
VMG1312-B Series User’s Guide
133
1 Ensure WPS is enabled on bot h devices.
2 Access t he WPS section of the AP’s configuration interface. See the device’s User’s Guide for how t o
do this.
3 Look for t he client ’s WPS PI N; it will be displayed eit her on the device, or in the WPS section of the
client ’s configuration int erface (see the device’s User’s Guide for how t o find the WPS PI N - for the
Device, see
Section 7.5 on page 118) .
4 Ent er the client ’s PI N in t he AP’s configuration int erface.
5 I f t he client device’s configurat ion interface has an area for ent ering anot her device’s PI N, you can
either enter the client ’s PI N in t he AP, or ent er t he AP’s PI N in t he client - it does not m at t er which.
6 St art WPS on both devices within two m inut es.
7 Use the configuration utility t o activat e WPS, not the push- but t on on the device it self.
8 On a com put er connect ed to the wireless client, t ry to connect to the I nternet. I f you can connect,
WPS was successful.
I f you cannot connect, check t he list of associated wireless client s in t he AP’s configuration ut ilit y. I f
you see t he wireless client in the list, WPS was successful.
To Next Page
Loading...
