ZyXEL Communications XGS4700-48F - Filtering; Chapter 12 Filtering; Configure a Filtering Rule

XGS4700-48F User’s Guide
147
CHAPTER 12
Filtering
This chapter discusses MAC address port filtering.
12.1 Configure a Filtering Rule
Configure the Switch to filter traffic based on the traffic’s source, destination MAC
addresses and/or VLAN group (ID).
Click Advanced Application > Filtering in the navigation panel to display the
screen as shown next.
Figure 60 Advanced Application > Filtering
The following table describes the related labels in this screen.
Table 25 Advanced Application > FIltering
LABEL DESCRIPTION
Active Make sure to select this check box to activate your rule. You may
temporarily deactivate a rule without deleting it by deselecting this check
box.
Name Type a descriptive name (up to 32 printable ASCII characters) for this rule.
This is for identification only.