Chapter 4 Web Configurator
XMG1930 Series User’s Guide
94
Errdisable This link takes you to a screens where you can view errdisable status and configure errdisable set-
tings in CPU protection, errdisable detect, and errdisable recovery.
IPv4 Source
Guard
Click the link to unfold the following sub-link menu.
IP Source
Guard
This link takes you to screens where you can configure filtering of unauthorized DHCP and ARP
packets in your network.
DHCP
Snooping
This link takes you to screens where you can view DHCP snooping database details and configure
DHCP snooping settings on ports or VLANs. You can use DHCP snooping to filter unauthorized
DHCP packets on the network and to build the binding table dynamically.
ARP
Inspection
This link takes you to screens where you can view ARP inspection status, and configure ARP
inspection settings on ports or VLANs. You can use ARP inspection to filter unauthorized ARP pack-
ets on the network.
IPv6 Source
Guard
Click the link to unfold the following sub-link menu.
IPv6 Static
Binding
The link takes you to screens where you can view IPv6 static binding status and manually create
IPv6 source guard static binding entries.
IPv6 Source
Guard
The link takes you to screens where you can define policies to have IPv6 source guard forward
valid addresses and/or prefixes and allow or block data traffic from all link-local addresses, and
apply the configured IPv6 source guard policy to a port.
IPv6
Snooping
The link takes you to screens where you can set up DHCPv6 snooping policies for the binding
table and enable the policies on VLAN interfaces.
DHCPv6
Trust Setup
The link takes you to a screen where you can specify which ports are trusted for DHCPv6 snoop-
ing.
Port Authenti-
cation
Click the link to unfold the following sub-link menu.
These links take you to screens where you can configure IEEE 802.1x port authentication as well as
MAC authentication for clients communicating through the Switch.
802.1x The link takes you to a screen where you can activate IEEE 802.1x security on a port.
MAC
Authentica
tion
The link takes you to a screen where you can activate MAC authentication on a port.
Guest
VLAN
The link takes you to a screen where you can activate enable and assign a guest VLAN to a port.
Compound
Authentica
tion Mode
The link takes you to a screen where you can allow network access for clients that pass either IEEE
802.1x authentication or MAC authentication, or pass both IEEE 802.1x authentication and MAC
authentication.
Port Security This link takes you to a screen where you can activate MAC address learning and set the
maximum number of MAC addresses to learn on a port.
MAINTENANCE
Certificates The link takes you to a screen where you can import the Switch's CA-signed certificates.
Cluster Man-
agement
This link takes you to a screen where you can configure clustering management and view its sta-
tus.
Configuration Click the link to unfold the following sub-link menu.
Restore
Configurati
on
Th
is link takes you to a screen where you can upload a stored device configuration file.
Backup
Configurati
on
This link takes you to a screen where you can save your Switch’s configurations (settings) for later
use.
Auto
Configurati
on
This link takes you to a screen where you can overwrite the running configuration stored in the
Switch’s RAM.
Table 30 Navigation Panel Links (Standard Mode) (continued)
LINK DESCRIPTION
To Next Page
Loading...
