Chapter 4 Web Configurator
XMG1930 Series User’s Guide
95
The following table describes the links in the navigation panel when the Switch is in Networked AV
mode.
Erase
Running-
Configurati
on
This link takes you to a screen where you can reset the configuration to the Zyxel default configu-
ration settings.
Save
Configurati
on
This link takes you to a screen where you can save the current configuration (settings) to a spe-
cific configuration file on the Switch.
Configure
Clone
This link takes you to a screen where you can copy the basic and advanced settings from a
source port to a destination port or ports.
Diagnostic This link takes you to a screen where you can ping IP addresses, run traceroute, test ports and
show the location of the Switch.
Firmware
Upgrade
This link takes you to a screen to upload firmware to your Switch.
Reboot System This link takes you to a screen to reboot the Switch without turning the power off.
Service
Register
This link takes you to a screen where you can view the status of your service registrations and
upgrade licenses.
Tech-Support This link takes you to a screen where you can download related log reports for issue analysis. Log
reports include CPU history and utilization, crash and memory.
Table 31 Navigation Panel Links (Networked AV Mode)
LINK DESCRIPTION
SUMMARY This screen displays the Switch’s front panel port status, connected ports, used power, Nebula
Cloud Control status, and Networked AV status.
MONITOR
System
Information
This link takes you to a screen that displays general system information.
SYSTEM
Cloud
Management
This screen displays a link to a screen where you can enable or disable the Nebula Control
Center (NCC) Discovery feature. If it is enabled, you can have the Switch search for the NCC
(Nebula Control Center). The screen also has a QR code containing the Switch’s serial number
and MAC address for handy registration of the Switch at NCC.
General Setup This link takes you to a screen where you can configure general identification information
about the Switch.
IP Setup This screen allows you to configure the IP address and subnet mask (necessary for Switch
management) and set up to 64 IP routing domains.
Logins This link takes you to a screen where you can change the system login password, as well as
configure up to four login details.
SNMP This link takes you to screens where you can specify the SNMP version and community
(password) values, configure where to send SNMP traps from the Switch, enable loopguard/
errdisable/poe/linkup/linkdown/lldp/transceiver-ddm/storm-control on the Switch, specify the
types of SNMP traps that should be sent to each SNMP manager, and add/edit user
information.
PORT
Link Aggregation This link takes you to screens where you can logically aggregate physical links to form one
logical, higher-bandwidth link.
PoE Setup For PoE models.
This link takes you to a screen where you can set priorities, PoE power-up settings and schedule
so that the Switch is able to reserve and allocate power to certain PDs.
Table 30 Navigation Panel Links (Standard Mode) (continued)
LINK DESCRIPTION
To Next Page
Loading...
