ZyXEL Communications ZYWALL 35 - Checking WAN Connections; Configuring Load Balancing; Figure 63 Tutorial: Home

Chapter 4 Tutorials
ZyWALL 5/35/70 Series User’s Guide
132
4.4.3 Checking WAN Connections
1 Go to the web configurator’s Home screen.
2 In the network status table, make sure the status for WAN 1 and WAN 2 is not Down
and there is an IP address. If the WAN 2 connection is not up, make sure you have
entered the correct information in the NETWORK > WAN > 3G (WAN 2) screen and
the signal strength to the service provider’s base station is not too low and can connect to
a network.
Figure 63 Tutorial: Home
4.5 Configuring Load Balancing
In this example, you have set up WAN 1 and WAN 2 and you want the ZyWALL to use both
of the WAN interfaces at the same time. You also balance the load between the two WAN
interfaces using the weighted round-robin method.
1 Click NETWORK > WAN > General.
2 Set the WAN operation mode to active/active and select Weighted Round-Robin in the
Load Balancing Algorithm field.
3 Enter 6 as the weight for WAN 1 and 4 for WAN 2.
4 Click Apply.