ZyXEL Communications ZYWALL 35 - Example 2: Linux; Figure 300 SSH Example 1: Store Host Key; Figure 301 SSH Example 2: Test

Chapter 26 Remote Management
ZyWALL 5/35/70 Series User’s Guide
504
Figure 300 SSH Example 1: Store Host Key
Enter the password to log in to the ZyWALL. The SMT main menu displays next.
26.9.2 Example 2: Linux
This section describes how to access the ZyWALL using the OpenSSH client program that
comes with most Linux distributions.
1 Test whether the SSH service is available on the ZyWALL.
Enter “telnet 192.168.1.1 22” at a terminal prompt and press [ENTER]. The
computer attempts to connect to port 22 on the ZyWALL (using the default IP address of
192.168.1.1).
A message displays indicating the SSH protocol version supported by the ZyWALL.
Figure 301 SSH Example 2: Test
2 Enter “ssh –1 192.168.1.1”. This command forces your computer to connect to
the ZyWALL using SSH version 1. If this is the first time you are connecting to the
ZyWALL using SSH, a message displays prompting you to save the host information of
the ZyWALL. Type “yes” and press [ENTER].
Then enter the password to log in to the ZyWALL.
$ telnet 192.168.1.1 22
Trying 192.168.1.1...
Connected to 192.168.1.1.
Escape character is '^]'.
SSH-1.5-1.0.0