ZyXEL Communications ZYWALL 35 - Configuring Class Setup; Figure 265 ADVANCED > BW MGMT > Class Setup

Chapter 24 Bandwidth Management
ZyWALL 5/35/70 Series User’s Guide
467
24.12 Configuring Class Setup
The Class Setup screen displays the configured bandwidth classes by individual interface.
Select an interface and click the buttons to perform the actions described next. Click “+” to
expand the class tree or click “-“ to collapse the class tree. Each interface has a permanent root
class. The bandwidth budget of the root class is equal to the speed you configured on the
interface (see Section 24.11 on page 465 to configure the speed of the interface). Configure
sub-class layers for the root class.
To add or delete child classes on an interface, click ADVANCED > BW MGMT > Class
Setup. The screen is shown here with example classes.
Figure 265 ADVANCED > BW MGMT > Class Setup
Maximize
Bandwidth
Usage
Select this check box to have the ZyWALL divide up all of the interface’s unallocated
and/or unused bandwidth among the bandwidth classes that require bandwidth. Do
not select this if you want to reserve bandwidth for traffic that does not match a
bandwidth class (see Section 24.7.4 on page 461) or you want to limit the speed of
this interface (see the Speed field description).
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Table 145 ADVANCED > BW MGMT > Summary (continued)
LABEL DESCRIPTION