EasyManua.ls Logo

ZyXEL Communications ZYWALL 35 - Chapter 13 Configuring IDP; Overview; Interfaces

ZyXEL Communications ZYWALL 35
872 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ZyWALL 5/35/70 Series User’s Guide
279
CHAPTER 13
Configuring IDP
This chapter shows you how to configure IDP on the ZyWALL.
13.1 Overview
To use IDP on the ZyWALL, you need to insert the ZyWALL Turbo Card into the rear panel
slot of the ZyWALL. See the ZyWALL Turbo Card guide for details.
" Turn the ZyWALL off before you install or remove the ZyWALL Turbo card.
" The ZyWALL Turbo Card does not have a MAC address.
13.1.1 Interfaces
The ZyWALL checks traffic going in the direction(s) you specify for signature matches.
If a packet matches a signature, the action specified by the signature is taken. You can change
the default signature actions in the Signatures screen. In the following figure the ZyWALL is
set to check traffic coming from either WAN interface to the LAN.

Table of Contents

Other manuals for ZyXEL Communications ZYWALL 35

Related product manuals