Chapter 10 WLAN
ZyWALL 5/35/70 Series User’s Guide
239
10.17 MAC Filter
The MAC filter screen allows you to configure the ZyWALL to give exclusive access to
specific devices (Allow Association) or exclude specific devices from accessing the
ZyWALL (Deny Association). Every Ethernet device has a unique MAC (Media Access
Control) address. The MAC address is assigned at the factory and consists of six pairs of
hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC
addresses of the devices to configure this screen.
To change your ZyWALL’s MAC filter settings, click WIRELESS > Wi-Fi > MAC Filter.
The screen appears as shown.
Figure 130 WIRELESS > Wi-Fi > MAC Filter
The following table describes the labels in this menu.
Table 66 WIRELESS > Wi-Fi > MAC Filter
LABEL DESCRIPTION
Active Select or clear the check box to enable or disable MAC address filtering.
Enable MAC address filtering to have the router allow or deny access to wireless
stations based on MAC addresses. Disable MAC address filtering to have the router not
perform MAC filtering on the wireless stations.
Association Define the filter action for the list of MAC addresses in the MAC address filter table.
Select Deny to block access to the router, MAC addresses not listed will be allowed to
access the router. Select Allow to permit access to the router, MAC addresses not
listed will be denied access to the router.
# This is the index number of the MAC address.
User Name Enter a descriptive name for the MAC address.
MAC
Address
Enter the MAC addresses (in XX:XX:XX:XX:XX:XX format) of the wireless stations that
are allowed or denied access to the ZyWALL in these address fields.
To Next Page
Loading...
