ZyXEL Communications ZYWALL 35 - Figure 464 Restore Using FTP Session Example; Figure 465 System Maintenance: Restore Configuration; Figure 466 System Maintenance: Starting Xmodem Download Screen; Figure 467 Restore Configuration Example

Chapter 48 Firmware and Configuration File Maintenance
ZyWALL 5/35/70 Series User’s Guide
722
48.4.2 Restore Using FTP Session Example
Figure 464 Restore Using FTP Session Example
Refer to Section 48.3.5 on page 718 to read about configurations that disallow TFTP and FTP
over WAN.
48.4.3 Restore Via Console Port
Restore configuration via console port by following the HyperTerminal procedure shown next.
Procedures using other serial communications programs should be similar.
1 Display menu 24.6 and enter “y” at the following screen.
Figure 465 System Maintenance: Restore Configuration
2 The following screen indicates that the Xmodem download has started.
Figure 466 System Maintenance: Starting Xmodem Download Screen
3 Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.
Figure 467 Restore Configuration Example
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...CCCCCCCCC
Type the configuration file’s location,
or click Browse to search for it.
Choose the Xmodem protocol.
Then click Send.