Chapter 24 Bandwidth Management
ZyWALL 5/35/70 Series User’s Guide
471
24.12.2 Bandwidth Management Statistics
Click ADVANCED > BW MGMT > Class Setup > Statistics to open the Bandwidth
Management Statistics screen. This screen displays the selected bandwidth class’s bandwidth
usage and allotments.
Source Address Type Do you want your rule to apply to packets coming from a particular (single) IP,
a range of IP addresses (for example 192.168.1.10 to 192.169.1.50) or a
subnet? Select Single Address, Range Address or Subnet Address.
Source IP Address Enter the single IP address or the starting IP address in a range here.
Source End Address
/ Subnet Mask
If you are configuring a range of IP addresses, enter the ending IP address
here. If you are configuring a subnet of addresses, enter the subnet mask here.
Refer to Appendix E on page 803 for more information on IP subnetting.
Source Port Enter the starting and ending destination port numbers. Enter the same port
number in both fields to specify a single port number. See Appendix F on page
813 for a table of services and port numbers.
Protocol ID Enter the protocol ID (service type) number, for example: 1 for ICMP, 6 for TCP
or 17 for UDP.
Apply Click Apply to save your changes back to the ZyWALL.
Cancel Click Cancel to exit this screen without saving.
Table 148 Services and Port Numbers
SERVICES PORT NUMBER
ECHO 7
FTP (File Transfer Protocol) 21
SMTP (Simple Mail Transfer Protocol) 25
DNS (Domain Name System) 53
Finger 79
HTTP (Hyper Text Transfer protocol or WWW, Web) 80
POP3 (Post Office Protocol) 110
NNTP (Network News Transport Protocol) 119
SNMP (Simple Network Management Protocol) 161
SNMP trap 162
PPTP (Point-to-Point Tunneling Protocol) 1723
Table 147 ADVANCED > BW MGMT > Class Setup > Add Sub-Class (continued)
LABEL DESCRIPTION
To Next Page
Loading...
