Chapter 38 DMZ Setup
ZyWALL 5/35/70 Series User’s Guide
637
" DMZ, WLAN and LAN IP addresses must be on separate subnets. You must
also configure NAT for the DMZ port (see Chapter 43 on page 663) in menus
15.1 and 15.2.
38.3.2 IP Alias Setup
Use menu 5.2 to configure the first network. Move the cursor to the Edit IP Alias field, press
[SPACE BAR] to choose Yes and press [ENTER] to open Menu 5.2.1 - IP Alias Setup, as
shown next. Use this menu to configure the second and third networks.
Figure 385 Menu 5.2.1: IP Alias Setup
Refer to Table 226 on page 627 for instructions on configuring IP alias parameters.
Menu 5.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
To Next Page
Loading...
