ZyXEL Communications ZyWall USG20-VPN - The Port Statistics Screen

Chapter 6 Monitor
USG20(W)-VPN Series User’s Guide
102
•Use the VPN Monitor > IPSec screen (Section 6.15 on page 123) to display and manage active
IPSec SAs.
•Use the VPN Monitor > SSL screen (see Section 6.16 on page 124) to list the users currently
logged into the VPN SSL client portal. You can also log out individual users and delete related
session information.
•Use the VPN Monitor > L2TP over IPSec screen (see Section 6.17 on page 125) to display and
manage the USG’s connected L2TP VPN sessions.
•Use the UTM Statistics > Content Filter screen (Section 6.18 on page 126) to start or stop
data collection and view content filter statistics.
•Use the UTM Statistics > Anti-Spam screen (Section 6.19 on page 128) to start or stop data
collection and view spam statistics.
•Use the UTM Statistics > Anti-Spam > Status screen (Section 6.19.2 on page 130) to see
how many mail sessions the USG is currently checking and DNSBL statistics.
•Use the Log screens (Section 6.20 on page 131) to view the USG’s current log messages. You
can change the way the log is displayed, you can e-mail the log, and you can also clear the log in
this screen.
6.2 The Port Statistics Screen
Use this screen to look at packet statistics for each Gigabit Ethernet port. To access this screen,
click Monitor > System Status > Port Statistics.
Figure 87 Monitor > System Status > Port Statistics
The following table describes the labels in this screen.
Table 32 Monitor > System Status > Port Statistics
LABEL DESCRIPTION
Poll Interval Enter how often you want this window to be updated automatically, and click Set
Interval.
Set Interval Click this to set the Poll Interval the screen uses.
Stop Click this to stop the window from updating automatically. You can start it again by setting
the Poll Interval and clicking Set Interval.
Switch to
Graphic View
Click this to display the port statistics as a line graph.