Chapter 30 System
USG20(W)-VPN Series User’s Guide
576
30.10 FTP
You can upload and download the USG’s firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client.
30.10.1 Configuring FTP
To change your USG’s FTP settings, click Configuration > System > FTP tab. The screen appears
as shown. Use this screen to specify from which zones FTP can be used to access the USG. You can
also specify from which IP addresses the access can come.
Figure 407 Configuration > System > FTP
The following table describes the labels in this screen.
Table 246 Configuration > System > FTP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Service Control table to access the USG using this service.
TLS required Select the check box to use FTP over TLS (Transport Layer Security) to encrypt
communication.
This implements TLS as a security mechanism to secure FTP clients and/or servers.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Server
Certificate
Select the certificate whose corresponding private key is to be used to identify the USG for
FTP connections. You must have certificates already configured in the My Certificates
screen.
Service Control This specifies from which computers you can access which USG zones.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry. Refer to Table 242 on page 559 for details on the screen that opens.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The USG confirms you want to remove it
before doing so. Note that subsequent entries move up by one when you take this action.
To Next Page
Loading...
