ZyXEL Communications ZyWall USG20-VPN - User;Group MAC Address Summary Screen

Chapter 29 Object
USG20(W)-VPN Series User’s Guide
467
The following table describes the labels in this screen.
29.2.5 User/Group MAC Address Summary Screen
This screen shows the MAC addresses of wireless clients, which can be authenticated by their MAC
addresses using the local user database. Click Configuration > Object > User/Group > MAC
Address to open this screen.
Note: You need to configure an SSID security profile’s MAC authentication settings to
have the AP use the USG’s local database to authenticate wireless clients by their
MAC addresses.
Figure 314 Configuration > Object > User/Group > MAC Address
The following table describes the labels in this screen.
Table 185 Web Configurator for Non-Admin Users
LABEL DESCRIPTION
User-defined
lease time (max
... minutes)
Access users can specify a lease time shorter than or equal to the one that you specified.
The default value is the lease time that you specified.
Renew Access users can click this button to reset the lease time, the amount of time remaining
before the USG automatically logs them out. The USG sets this amount of time according
to the
• User-defined lease time field in this screen
• Lease time field in the User Add/Edit screen (see Section 29.2.5.1 on page 468)
• Lease time field in the Setting screen (see Section 29.2.4 on page 462)
Updating lease
time
automatically
This box appears if you checked the Allow renewing lease time automatically box in
the Setting screen. (See Section 29.2.4 on page 462.) Access users can select this check
box to reset the lease time automatically 30 seconds before it expires. Otherwise, access
users have to click the Renew button to reset the lease time.
Remaining time
before lease
timeout
This field displays the amount of lease time that remains, though the user might be able to
reset it.
Remaining time
before auth.
timeout
This field displays the amount of time that remains before the USG automatically logs the
access user out, regardless of the lease time.
Table 186 Configuration > Object > User/Group > MAC Address
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.