ZyXEL Communications ZyWall USG20-VPN - Console Port Speed

Chapter 30 System
USG20(W)-VPN Series User’s Guide
544
7 Click Apply.
To get the USG date and time from a time server
1 Click System > Date/Time.
2 Select Get from Time Server under Time and Date Setup.
3 Under Time Zone Setup, select your Time Zone from the list.
4 As an option you can select the Enable Daylight Saving check box to adjust the USG clock for
daylight savings.
5 Under Time and Date Setup, enter a Time Server Address (Table 232 on page 543).
6 Click Apply.
30.5 Console Port Speed
This section shows you how to set the console port speed when you connect to the USG via the
console port using a terminal emulation program.
Click Configuration > System > Console Speed to open the Console Speed screen.
Figure 371 Configuration > System > Console Speed
The following table describes the labels in this screen.
Table 233 Configuration > System > Console Speed
LABEL DESCRIPTION
Console Port Speed Use the drop-down list box to change the speed of the console port. Your USG supports
9600, 19200, 38400, 57600, and 115200 bps (default) for the console port.
The Console Port Speed applies to a console port connection using terminal emulation
software and NOT the Console in the USG Web Configurator Status screen.
Apply Click Apply to save your changes back to the USG.
Reset Click Reset to return the screen to its last-saved settings.