Chapter 9 Interfaces
USG20(W)-VPN Series User’s Guide
169
Each field is described in the table below.
9.4.2 PPP Interface Add or Edit
Note: You have to set up an ISP account before you create a PPPoE/PPTP interface.
This screen lets you configure a PPPoE or PPTP interface. If you enabled IPv6 in the Configuration
> System > IPv6 screen, you can also configure PPP interfaces used for your IPv6 networks on
this screen. To access this screen, click the Add icon or an Edit icon in the PPP Interface screen.
Table 68 Configuration > Network > Interface > PPP
LABEL DESCRIPTION
User Configuration /
System Default
The USG comes with the (non-removable) System Default PPP interfaces pre-
configured. You can create (and delete) User Configuration PPP interfaces. System
Default PPP interfaces vary by model.
Add Click this to create a new user-configured PPP interface.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry’s settings.
Remove To remove a user-configured PPP interface, select it and click Remove. The USG
confirms you want to remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Connect To connect an interface, select it and click Connect. You might use this in testing the
interface or to manually establish the connection for a Dial-on-Demand PPPoE/PPTP
interface.
Disconnect To disconnect an interface, select it and click Disconnect. You might use this in testing
the interface.
Object References Select an entry and click Object Reference to open a screen that shows which
settings use the entry. See Section 9.3.2 on page 164 for an example.
# This field is a sequential value, and it is not associated with any interface.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry
is inactive.
The connect icon is lit when the interface is connected and dimmed when it is
disconnected.
Name This field displays the name of the interface.
Base Interface This field displays the interface on the top of which the PPPoE/PPTP interface is.
Account Profile This field displays the ISP account used by this PPPoE/PPTP interface.
Apply Click Apply to save your changes back to the USG.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
