Chapter 6 Monitor
USG20(W)-VPN Series User’s Guide
114
The following table describes the labels in this screen.
Table 42 Monitor > System Status > Cellular Status
LABEL DESCRIPTION
Refresh Click this button to update the information in the screen.
More Information Click this to display more information on your mobile broadband, such as the signal
strength, IMEA/ESN and IMSI. This is only available when the mobile broadband device
attached and activated on your USG. Refer to Section 6.11 on page 115.
# This field is a sequential value, and it is not associated with any interface.
Extension Slot This field displays where the entry’s cellular card is located.
Connected Device This field displays the model name of the cellular card.
Status • No device - no mobile broadband device is connected to the USG.
• No Service - no mobile broadband network is available in the area; you cannot
connect to the Internet.
• Limited Service - returned by the service provider in cases where the SIM card is
expired, the user failed to pay for the service and so on; you cannot connect to the
Internet.
• Device detected - displays when you connect a mobile broadband device.
• Device error - a mobile broadband device is connected but there is an error.
• Probe device fail - the USG’s test of the mobile broadband device failed.
• Probe device ok - the USG’s test of the mobile broadband device succeeded.
• Init device fail - the USG was not able to initialize the mobile broadband device.
• Init device ok - the USG initialized the mobile broadband card.
• Check lock fail - the USG’s check of whether or not the mobile broadband device is
locked failed.
• Device locked - the mobile broadband device is locked.
• SIM error - there is a SIM card error on the mobile broadband device.
• SIM locked-PUK - the PUK is locked on the mobile broadband device’s SIM card.
• SIM locked-PIN - the PIN is locked on the mobile broadband device’s SIM card.
• Unlock PUK fail - Your attempt to unlock a WCDMA mobile broadband device’s PUK
failed because you entered an incorrect PUK.
• Unlock PIN fail - Your attempt to unlock a WCDMA mobile broadband device’s PIN
failed because you entered an incorrect PIN.
• Unlock device fail - Your attempt to unlock a CDMA2000 mobile broadband device
failed because you entered an incorrect device code.
• Device unlocked - You entered the correct device code and unlocked a CDMA2000
mobile broadband device.
• Get dev-info fail - The USG cannot get cellular device information.
• Get dev-info ok
- The USG succeeded in retrieving mobile broadband device
information.
• Searching network - The mobile broadband device is searching for a network.
• Get signal fail - The mobile broadband device cannot get a signal from a network.
• Network found - The mobile broadband device found a network.
• Apply config - The USG is applying your configuration to the mobile broadband
device.
• Inactive - The mobile broadband interface is disabled.
• Active - The mobile broadband interface is enabled.
• Incorrect device - The connected mobile broadband device is not compatible with
the USG.
• Correct device - The USG detected a compatible mobile broadband device.
• Set band fail - Applying your band selection was not successful.
• Set band ok - The USG successfully applied your band selection.
• Set profile fail - Applying your ISP settings was not successful.
• Set profile ok - The USG successfully applied your ISP settings.
• PPP fail - The USG failed to create a PPP connection for the cellular interface.
• Need auth-password - You need to enter the password for the mobile broadband
card in the cellular edit screen.
• Device ready - The USG successfully applied all of your configuration and you can
use the mobile broadband connection.
To Next Page
Loading...
